How To Reset Audi A7 Air Suspension & Method

Resetting the air suspension on an Audi A7 (2010-2018) is an essential step to ensure the system functions correctly, especially after maintenance or repairs such as replacing air struts, compressors, or sensors. If you’re experiencing issues such as ride height inconsistencies or warning lights, a reset might be necessary.

Steps to Reset Audi A7 Air Suspension:

1. Ensure the Vehicle is in Proper Condition:

   • Park the car on a flat, level surface to ensure accurate calibration and reset.
   • Make sure the ignition is in the “On” position (engine running or in accessory mode) before starting the reset process.
   • If the suspension has been repaired, ensure the components (air struts, compressor, valve block, etc.) are installed correctly and functioning.

2. Use a Diagnostic Tool (OBD-II Scanner or VAG-COM):

   • To reset the air suspension control module, you'll need a professional OBD-II scanner or a VAG-COM (VCDS) diagnostic tool.
   • Connect the scanner to the OBD-II port located under the dashboard on the driver's side.

3. Access the Air Suspension Control Module:

   • After connecting the diagnostic tool, navigate to the “Air Suspension” or “Suspension Control Module” in the tool’s menu.
   • If you are using VAG-COM, you will need to go to the specific control module for air suspension, which is typically listed under "Address 34" (for air suspension) in the system.

4. Reset or Recalibrate the Air Suspension:

   • Once you’ve accessed the correct module, select the option to reset or recalibrate the air suspension.
   • Audi A7 Air Suspension Reset: This process will clear any stored fault codes and reset the suspension system to factory settings. The control unit will go through a series of checks and adjustments.

5. Check Ride Height Adjustments:

   • After the reset, the air suspension should automatically adjust the ride height to the default factory settings. The system will raise or lower each corner of the vehicle to the correct level.
   • If the suspension is functioning properly, the car should be level, with no sagging or uneven height at any corner.

6. Perform a System Test:

   • Use the diagnostic tool to perform a system test to verify that the air suspension is operating correctly.
   • The tool may prompt you to check whether the suspension is adjusting properly, including tests for height sensors, air compressor, and valve blocks.

7. Clear Fault Codes:

   • If there are any lingering fault codes or error messages on the display, use the scanner to clear them.
   • This will remove any warnings from the dashboard and ensure the system is functioning properly after the reset.

8. Test Drive the Vehicle:

   • After the reset and clearing of any fault codes, take the car for a short drive to ensure the air suspension is responding correctly.
   • Check for smooth transitions between ride height adjustments and listen for any unusual noises or issues.

---

Considerations:

• Persistent Issues: If the air suspension warning light remains on or if the system does not adjust properly after the reset, further diagnosis is needed. It may indicate a malfunctioning component such as a faulty height sensor, air compressor, or valve block.
• Professional Help: If you don’t have access to a diagnostic tool or if you’re unsure about performing the reset, it’s best to consult an Audi dealership or a qualified technician. The air suspension system is complex, and incorrect calibration or resets could lead to further issues.
• Regular Maintenance: Keeping up with routine maintenance and checking the air suspension system regularly can prevent many issues from arising, especially after repairs or component replacements.

By following the above steps, you should be able to reset the air suspension on your Audi A7 and ensure it operates correctly. If problems persist, it’s important to seek professional help to diagnose and repair the issue.